Sürdürülebilir Kalkınma Amaçları
Yayınlar
- MakaleYayıncıda açık erişim2025Efficient extraction and determination of Au(iii) ions from acid mine drainage and water samples using silica gel immobilized with Brevibacillus borstelensis
Camoglu, Aslihan Yilmaz; Duran, Celal; Ozdes, Duygu; Nalcaoglu, Aleyna; Bektas, Kadriye Inan; Belduz, Ali Osman
The analysis of gold, which is a precious metal with limited resources, in environmental samples is crucial for the sustainable utilization of natural resources. Therefore, in the present research we have aimed to develop a novel and environmentally friendly bioadsorbent, Brevibacillus borstelensis loaded on silica gel (BB@Si), with outstanding adsorptive properties that can be implemented for quantitative recovery of Au(iii) ions via the solid phase extraction (SPE) technique. After characterizing the developed adsorbent using FTIR and SEM techniques, we conducted a detailed investigation of the critical parameters that influence the extraction performance of Au(iii) ions. Optimum parameters were observed as follows: pH 3.0, adsorption contact time 30 min, eluent type 0.1% (w/v) thiourea in 0.5 M HNO3, elution time 60 min, BB@Si amount 1.0 g L−1, and sample volume 400 mL. Some of the well-known isotherm and kinetic models were applied to the results observed from the adsorption studies. Equilibrium adsorption capacity of BB@Si was estimated to be 66.2 mg g−1 utilizing the Langmuir isotherm model while the limit of detection (LOD) and relative standard deviation (RSD%) were established as 0.99 μg L−1 and 3.7%, respectively. The developed method was utilized smoothly for the quantification of Au(iii) ions in mining wastewater, acid mine drainage (AMD), streams and seawater.
- MakaleYalnız künye2024Adsorption of Azocarmine G dye on H2SO4-modified acacia sawdust
Duran, Celal; Ozeken, Sengul Tugba; Camoglu, Aslihan Yilmaz; Ozdes, Duygu
Presence of hazardous dyes in water cause considerable risks to the human health and environment due to their potential toxicity and ecological disruptions. Therefore, in the present research, to suggest an alternative method for the retention of toxic Azocarmine G (ACG) dye from aqueous media, natural and H2SO4-modified acacia sawdust were performed for the first time as low-cost and efficient adsorbents. Based on batch experiments, it was determined that the best conditions for the developed dye retention process were an initial pH of 2.0 and an equilibrium time of 240 min. Analysis of the data using both pseudo-first order and pseudo-second order kinetic models showed that the retention of ACG onto the adsorbents predominantly occurred through chemical adsorption. Langmuir, Freundlich, and Dubinin-Radushkevich isotherm models were employed to provide insights into the interaction between the adsorbate and adsorbent and the mechanism of the adsorption process. Maximum monolayer adsorption capacities of natural and H2SO4-modified acacia sawdust were determined as 28.01 and 64.90 mg g-1, respectively by Langmuir isotherm model. Results of the study clearly indicated that the modification of acacia sawdust with H2SO4 leads to a substantial increase in the adsorption performance of anionic dyes.
- MakaleAçık Erişim2023A green and simplified approach for the quantitative and sensitive analysis of heavy metal ions in sea and stream waters
Duran, Celal; Camoglu, Aslihan Yilmaz; Ozdes, Duygu; Bekircan, Olcay
Elimination of the matrix effect is a major challenge in developing a method for the quantification of heavy metals (HMs) in water samples. In this regard, the current research describes the simultaneous analyses of Cu(II), Cd(II), and Ni(II) ions in water matrices through flame atomic absorption spectrophotometry (FAAS) after preconcentration with carrier element-free co-precipitation (CEFC) technique by the help of an organic co-precipitant, 3-{[5-(4-Chlorobenzyl)-3-(4-chlorophenyl)-1H-1,2,4-triazol-1-yl]-methyl}-4-[2,4-(dichlorobenzylidene)amino]-1H-1,2,4- triazole-5(4H)-thione (CCMBATT). Based on our literature research, CCMBATT was employed for the first time in this study as an organic co-precipitant for the preconcentration of HMs. Factors such as solution pH, concentration of co-precipitant, sample volume, standing time, centrifugation rate, and time were thoroughly examined and optimized to achieve the highest efficiency in terms of HM recovery. The limits of detection (LODs) (with 10 number of tests) of 0.54, 0.34, and 1.95 μg L-1 and the relative standard deviations (RSD %) of 2.1, 3.3, and 3.0 were determined for Cu(II), Cd(II) and Ni(II) ions, respectively. Recovery results of HMs for the spiked samples were in the range of 92.8-101.0%, demonstrating the trueness of the method and its applicability to the water samples matrix.
- MakaleAçık Erişim2023Enhancement of adsorptive removal efficiency of an anionic dye from aqueous solutions using carboxylic acid-modified mulberry leaves: Artificial neural network modeling, isotherm, and kinetics evaluation
Duran, Celal; Ozeken, Sengul Tugba; Camoglu, Aslihan Yilmaz; Ozdes, Duygu
Natural mulberry leaves and carboxylic acid-modified mulberry (Morus alba L.) leaves were used for the first time to scrutinize the effects of modification on the retention efficiency of an anionic dye (Remazol Brilliant Blue R (RBBR)) from aqueous solutions to suggest an economical and promising adsorbent for the treatment of dye-contaminated water. The characterization of the adsorbents was accomplished through common techniques including SEM, FTIR, and pHpzc determination. Several parameters studied in batch experiments pointed out that the initial pH of 2.0 and the contact time of 240 min were optimum conditions for all the developed RBBR uptake processes. An artificial neural network (ANN) model was applied to formulate a forecast model for the uptake efficiency of RBBR. The experimental data were assessed by different kinetic and isotherm models to explain the mechanism of the developed processes in more detail. Maximum monolayer adsorption capacities of natural mulberry leaves and acetic acid-, citric acid-, and oxalic acid-modified mulberry leaves were determined as 64.5, 95.2, 84.8, and 91.7 mg g1, respectively, by the Langmuir isotherm model. These results demonstrated that the modification with carboxylic acids significantly increases the anionic dye adsorption capacity of the mulberry leaves.