Sürdürülebilir Kalkınma Amaçları
Yazarlar
- Ozyurt, E.(2)
- Das, S.(1)
Yayınlar
- MakaleYalnız künye2020Scopus SJRQ1Finite element study on axially loaded reinforced Square Hollow Section T-joints at elevated temperatures
Ozyurt, E.
This study numerically investigates the elevated temperature resistance of collar plate and doubler plate reinforced Square Hollow Section (SHS) T-joints subjected to brace axial compressive load. The extensive numerical simulations were performed to examine the effects of the geometrical parameters of main members and reinforcing plate on the fire resistance of reinforced SHS T-joints after verification of the numerical models based on the available test results. The corresponding unreinforced joints were also analysed as reference resistance at five different temperature levels (20 °C, 400 °C, 500 °C, 600 °C, and 700 °C). Results indicate that the elevated temperature capacity of SHS T-joints can be significantly increased by using a collar plate or a doubler plate. Although the initial stiffness of the doubler plate reinforced joints was higher than the collar plate reinforced joints, their capacity was similar to each other. Also, the fire resistance of the reinforced joints mainly depended on the brace-to-chord width ratio and reinforcing plate thickness to chord wall thickness ratio. However, there was no beneficial effect on the fire resistance of reinforced joints when the thickness of the reinforcing plate was greater than 1.5 times the chord wall thickness. Moreover, there was an insignificant effect of half-width to thickness ratio of the chord, reinforcing length and reinforcing type as long as the required limit values of the reinforcing length and width were used based on the Eurocode 3 EN 1993-1-8. It is worth mentioning that modifying the steel yield strength in the ambient temperature design method to calculate the capacity of the reinforced SHS T-joints at elevated temperatures may be unsafe. A new design method was developed to predict the capacity of a collar plate and doubler plate reinforced SHS T-joints subjected to brace compressive load in fire.
AtıfScopus14WoS13OpenAlex14
İncele - MakaleAçık Erişim2019Scopus SJRQ1Experimental and numerical studies on axially loaded reinforced square hollow section T-joints
Ozyurt, E.; Das, S.
This paper presents outcomes of experimental and numerical studies completed on unreinforced, collar plate reinforced and doubler plate reinforced Square Hollow Section (SHS)T-joints subjected to axial compressive loading on the brace member. A total of nine full-scale SHS T-joint specimens were fabricated and tested, in which six specimens were reinforced with collar plate and doubler plate. Non-linear finite element (FE)models were developed using finite element code, ABAQUS. Test data was used to validate these FE models. Subsequently, validated FE models were used to conduct an extensive parametric study to investigate the effect of various geometrical parameters of main members and reinforcement plates on the ultimate capacity of reinforced SHS T-joints. The parametric study found that use of both collar and doubler plate reinforcements significantly increase the ultimate capacity of SHS T-joints. Thickness of the reinforcing plate has a positive effect if the thickness of the reinforcing plate is limited to twice the thickness of the chord member. This study, however, found that the capacity of a reinforced SHS T-joint is not dependent on the type of reinforcing plate. The study concludes that the maximum capacity that can be achieved from a reinforced joint is about double the capacity of a similar unreinforced joint. It was found that the Eurocode EN 1993-1-8 overestimates the capacity of reinforced SHS T-joints. Therefore, a new design method for predicting the ultimate capacity of the collar plate and doubler plate reinforced SHS T-joints was developed and this new design method is presented in this paper.
AtıfScopus30WoS27OpenAlex27İncele