Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleAçık Erişim2021Production and characterization of zinc oxide nanoparticles in microsystems via green synthesis; [Yeşil sentez yoluyla mikrosistemlerde çinko oksit nanopartiküllerin üretimi ve karakterizasyonu]
Akay, Şeref; Sefaoğlu, Melike
Nanoparticles (NP), which can be produced for many different fields and purposes; are at size vary from nanometer to a micrometer. These particles can be prepared by different approaches such as chemical, physical and biological methods. However, the biological approach is the most promising approach among other methods due to its simplicity and environmentally friendly conditions. The production of the nanoparticle by means of a biological approach does not require any high temperature, acidic/basic conditions and hazardous chemicals. Therefore, this method is named “green synthesis”. Development in microtechnology has had profound effects in many areas such as drug discovery, biology, diagnosis, and tissue engineering. Microfluidics which focuses on the processing of liquids in microscale systems has attracted wide attention in the production process of nanoparticles due to precise control and fast mixing. The main purpose of this study is to produce and characterize metal nanoparticles by combining microsystems and green synthesis approaches. For this purpose, in the first step, the design of microsystems that suitable for the flow of different phases was performed. In the second step, ZnO nanoparticle synthesis was carried out using the red cabbage (Brassica oleracea var.capitata f. Rubra) extracts. The synthesis of nanoparticles achieved by optimizing different parameters such as; extract: zinc ratio, zinc solution concentration, flow rates, and flow rates ratio in the microsystem and temperature. The results showed that the herbal red cabbage components can be used for the green synthesis of ZnO nanoparticles.
- MakaleAçık Erişim2015Preparation and characterization of electroless Ni-B/nano-SiO2, Al2O3, TiO2 and CuO composite coatings
Ekmekci, Dursun; Bülbül, Ferhat
Ni-B/SiO2, Al2O3, TiO2 and CuO composite coatings were successfully obtained by the electroless plating technique. Dispersible SiO2, Al2O3, TiO2 and CuO nanoparticles were co-deposited with electroless Ni-B coating onto AISI-304 steel substrates. Deposits were characterized for its structural properties by X-ray diffraction (XRD). XRD results showed a broad peak of Ni-B and low intensity composite nanoparticle peaks. The surface and cross-section morphology of samples were analysed using a scanning electron microscope (SEM). Surface analysis showed that the incorporation in Ni-B matrix of nano-SiO2, Al2O3, TiO2 and CuO particles increases the nodularity of composite coatings. The deposits are composed of a columnar structure grown along the vertical direction of the substrate surface. The results also show that electroless nanocomposite coatings tend to have greater microhardness compared with the coating without nanoparticles. The increase in the microhardness of the nanocomposite coatings reported in this study is attributed to an effect of dispersion strengthening of ceramic particles in the Ni-B matrix.