Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleAçık Erişim2024Scopus SJRQ2Design and fabrication of low-cost microsystems for production of chitosan particles; [Kitosan parçacıklarının üretimi için düşük maliyetli mikrosistemlerin tasarımı ve fabrikasyonu]
Akay, Seref; Özdilek, Hasret
Recent research has focused on the methods for administration of medications in a controlled manner while minimizing side effects. Cross-linked hydrogels have wide application area as nanocarriers. There are many approaches for developing suitable methods to produce ideal particles. Advances in microtechnology have been considered as a solution to produce controlled drug delivery systems, however, it is limited due to the necessity for specialized laboratories. In this study, a simple method to produce antibiotic-loaded chitosan particles is proposed. Production was carried out with two different designs, a syringe-based flow focusing system (outer diameter of 1 mm, inner diameter of 120 µm) and microchannel with 250 µm width and 100 µm height fabricated with the computer numerical control (CNC). Sodium Triphosphate (TPP) was used as cross-linking agent for the production of particles and the effects of the concentration and flow rates on the particle formation was investigated. It has been observed that particles can be produced in a syringe-based system, but the resulting particles are not homogeneous. In the studies carried out with CNC microchannel, it was determined by SEM analysis that the obtained particles ranged in size from 39 to 771 nm, and it was seen that the CNC microchannel was more effective at low and equal flow rates (25 µl/min). It has been found that increasing the flow rate and concentration of chitosan increases the particle size. It was determined that Ampicillin loaded particles synthesized with the CNC microchannel exhibited high inhibition against Gram positive and Gram negative bacteria. These results show that the proposed approaches for the design of microsystems can be used in the formation of drug carriers without the need for specialized laboratories and expertise.
AtıfScopus1
İncele - MakaleYalnız künye2017Scopus SJRQ1An injectable alginate-based hydrogel for microfluidic applications
Akay, Seref; Heils, Rene; Trieu, Hoc Khiem; Smirnova, Irina; Yesil-Celiktas, Ozlem
The objective of this study was to develop an injectable alginate based formulation for immobilizing enzymes into microfluidic systems. The gelation was induced upon lowering the pH by addition of D-glucono-δ-lactone (GDL) and release of Ca+ ions from solid CaCO3. The effects of GDL concentration on enzymatic activity and gelation time were investigated. The results indicated that increasing the GDL concentration increased both surface area and enzymatic activity. Also, chitosan was added to the formulation at different ratios to enhance the stability of enzyme during immobilization. For microfluidic application, 100 μl spiral coil single channel microchip was fabricated and alginate GDL mixture containing β-glucosidase was injected to the microchannel prior to gelation. Enzymatic conversion was performed by pumping substrate (pNPG) through the microchannel. The results indicated that the entire substrate was converted continuously during 24 h without any leakage or deactivation of immobilized enzyme.
AtıfScopus42WoS34OpenAlex38
İncele