Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleYalnız künye2026Scopus SJRQ1Analysis of microstructural properties and durability characteristics of geopolymer mortars with mining waste
Aksüt, Yavuz Selim; Kaya, Yusuf; Sünnetçi, Kadir
The growing environmental concerns over resource depletion and carbon emissions from cement production have accelerated the search for sustainable alternatives to conventional concrete. In this context, geopolymers have emerged as promising binders, particularly through the utilization of aluminosilicate-rich industrial wastes to reduce environmental impact and support waste recycling. This study examines the mechanical and durability properties of geopolymer mortars produced by partially replacing ground granulated blast furnace slag (GGBFS) with mining waste (MW) at ratios of 0%, 10%, 20%, and 30%. The mixtures were activated using 10 M sodium hydroxide and sodium silicate under standard water curing conditions. Mechanical strength, ultrasonic pulse velocity (UPV), freeze–thaw resistance, and sulfate durability were evaluated. The optimum performance was obtained with 20% MW, which achieved a 30.4% increase in flexural strength and 18% in compressive strength at 7 days. This mixture also showed the lowest mass (10.69%) and strength loss (18.36%) after 50 freeze–thaw cycles. Scanning electron microscopy analysis confirmed enhanced gel formation and microstructural densification. The findings demonstrate that controlled use of MW not only improves durability but also promotes sustainable binder development in geopolymer technology.
AtıfScopus1OpenAlex1İncele - MakaleAçık Erişim2025Scopus SJRQ2Comprehensive study on the role of mycrisparite in enhancing strength, stability, and microstructural traits of self-compacting mortars
Etli, Serkan; Yılmaz, Tekin
The present research work aims at promoting the mechanical, durability and microstructure performances of self-compacting mortars (SCMs) and lessening the cement production-induced costs and environmental difficulties, by replacing binder with definite proportions (2.5–15%) of MS. To achieve these goals, the compressive and flexural strength (UCS, FS), freeze–thaw (F–T), sorptivity (Sp), MIP (tP, psD) and SEM tests were conducted on SCMs cured for diverse (7–90 days) ages. The outcomes unearthed that replacing binder with MS at small proportions boosted the UCS/FS performances of SCMs. These improvements in strength performance compared to MS-0 were more spectacular in MS-2.5, which produced higher UCS and FS of 8.6–21.0% and 10.0–25.7%, respectively at all curing ages. Similarly, the same SCMs, which betrayed lower UCS- (10.3 < 16.7) and FS-losses (31.6 < 41.0) than the control at the end of the 200-cycle F–T test, were able to remain more endurance against F–T deterioration. Besides, MS replacement up to 10% enabled the SCMs to exhibit lower tP- (up to 11.2%) and Sp values (up to 61.2%) by ameliorating the psD (refining the larger pores into finer pores). The current research can be consequently commented to provide more beneficial SCM design on both strength/stability and microstructure, and cost and environmental troubles for the building industry.
AtıfScopus4WoS5OpenAlex6İncele