Yazarlar
- Ozyurt, E.(2)
- Wang, Y.C.(2)
Yayınlar
- MakaleAçık Erişim2019A numerical investigation of static resistance of welded planar steel tubular joints under in-plane and out-of-plane bending at elevated temperatures
Ozyurt, E.; Wang, Y.C.
This study presents the results of a numerical investigation on static resistance of welded planar steel tubular joints under in-plane and out-of-plane bending moments at elevated temperatures. The numerical simulations were carried out using the commercial finite Element software ABAQUS v6.14-1 and the simulation model was validated by comparing against test results for CHS joints under brace in-plane bending at elevated temperatures. Extensive numerical parametric simulations were performed for CHS/SHS/EHS joints under in-plane and out-of-plane bending at elevated temperatures, to establish a database of results covering a wide range of geometrical parameters, including brace to chord diameter ratio, the angle between brace to chord members, and chord diameter to twice chord thickness ratio. The ratios of joint elevated temperature resistance to ambient temperature resistance were compared to the steel yield strength reduction factor, the steel Young's modulus reduction factor, and the average of the above these reduction factors at different elevated temperatures. Based on the comparisons, it has been found that using the reduction factor for the yield strength of steel to modify the ambient temperature equations will overestimate the resistance of joints at elevated temperatures. As a simplified and safe recommendation, the ambient temperature joint resistance equations can be modified by the average reduction factors for the Young's modulus and yield strength at elevated temperatures. This modification factor can be increased to the yield strength reduction factor when the brace and chord widths/diameters are the same.
- MakaleAçık Erişim2018Resistance of Axially Loaded T- and X-Joints of Elliptical Hollow Sections at Elevated Temperatures – A Finite Element Study
Ozyurt, E.; Wang, Y.C.
This study presents the results of a numerical study to develop a method to calculate the static strength of welded Elliptical Hollow Section (EHS) joints at elevated temperatures. Extensive numerical simulations using the non-linear finite element package, ABAQUS v6.14–1 on EHS T- and X-joints under brace axial compression or tension and pre-stress in chord member with different type of joint orientations at elevated temperatures over a wide range of diameter ratio have been conducted. The adjustments required to be made to the equations of joint resistance under ambient temperature conditions for estimating joint resistance at elevated temperature conditions are investigated in this study. The FE simulation results have been compared with the calculation results of a number of existing methods at ambient temperature. It has been found that the method proposed by Packer et al. gives the best agreement with the authors' simulation results at ambient temperature. At elevated temperatures, for T- and X- joints with braces in compression welded to the wide sides of chords, replacing the ambient temperature yield strength of steel by the elevated temperature value in the current design method overestimates the ultimate load carrying capacity of axially loaded EHS T- and X-joints due to inability of the ambient temperature calculation equations to take into consideration EHS flattening at high temperatures. For these cases, it is recommended to calculate the joint strength reduction factor at elevated temperatures according to the Young's modulus of steel.