Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleYayıncıda açık erişim2022Tectonic and structural characteristics of Erzurum and its surroundings (Eastern Turkey): a detailed comparison between different geophysical parameters
Özer, Çağlar; Öztürk, Serkan; Pamuk, Eren
The tectonic and structural properties of Erzurum and its surroundings have been investigated by evaluating the seismo-tectonic b-value, magnetic anomaly, edge detection analysis (total horizontal derivative (THDR) and tilt angle (TA)), Curie Point Depth (CPD), P-wave velocity (Vp), and Vp / Vs (S-wave velocity) ratio and by imaging the regional distributions of these parameters. For this purpose, all parameters have been combined to be able to reveal the new useful results on the study region and are presented for different locations and depths. The Vp values have been accompanied by high Vp / Vs ratios and shallow CPD values in the areas with geothermal regions such as Tekman, Söylemez, and the northern part of Karlıova. In the tectonically active regions such as Ilıca, Dumlu, Pasinler, Çat, Karlıova and Karaçoban, high reduction-to – the-pole (RTP) total magnetic anomaly was accompanied by low Vp values in harmony. Besides, the low Vp values between 0 and 10 km and high b-values can be related to the weakness zones and the areas in which earthquake hazards are high in the study area. The low Vp values in the 0 km horizontal slice are in accordance with the high RTP total magnetic anomaly values in the triangle area between Aşkale, Ilıca-Dumlu-Pasinler, Narman, and Karaçoban. Uniformly, high Vp and low RTP total magnetic anomaly inclusions overlap in Çat and Tekman. In some regions such as Dumlu, Narman, Horasan, Karaçoban and south of Karlıova, the tilt angle values are positive (positive values in the tilt angle map correspond to the center of the structure causing the magnetic anomaly) and the Vp values are low, but there is not a complete harmony between these parameters. These results show that variations on these parameters are related to each other, and these types of geophysical data are required for tectonic and structural features at different locations and depth levels.
- Kitap BölümüYalnız künye2020Geothermal Potential and Circulation Depth of Hudai Thermal Springs (Sandikli-Afyonkarahisar, Turkiye) Using Magnetic, Geothermometry and Heat Flow Data
Maden, Nafiz; Afsin, Mustafa; Aksever, Fatma; Davraz, Aysen; Biswas, A; Sharma, SP
The Hudai-Sandikli geothermal basin having 23 thermal productivity wells is a significant geothermal energy source field. The analysis of power spectrum, conventional heat flow and silica heat flow methods were implemented to identify the geothermal waters circulation depth, depth to Curie point and surface heat flow rate in the Hudai-Sandikli geothermal field. Hydrogeochemical facies of geothermal immature ancient waters having deep circulation in lower hydraulic conductive aquifers are Na-Ca-HCO3-SO4 and Na-Ca-SO4-HCO3, which is represented very high ion content because of extensive contact with rocks. The heat conduction law is employed to specify the rate of heat flow using the geothermal gradient value. The numerical results determined from silica geothermometer method, the mean heat flow density and Curie temperature depth are obtained as 103.69 mWm(-2) and 11.81 km, respectively. The study region was represented by a mean geothermal gradient of 49.18 degrees C km(-1) yielding average reservoir depths of 0.90 km. The estimated Curie temperature, heat flow, reservoir temperature values demonstrated that the region indicates significant geothermal energy potential because of the partial melting of lithospheric crust.
- Kitap BölümüYalnız künye2013Geophysical approach for the detection and evaluation of geothermal energy potential stimulated from geology and tectonics in Cappadocia Region (Central Turkey)
Maden, Nafiz
Geothermal energy, which is a renewable energy source, can be used to heat buildings or generate electricity and does not contribute to air pollution when used properly, and it is heat continuously produced inside the earth that generates geological phenomena on a planetary scale. Central Anatolia is a triangular region which is limited by North Anatolian Fault Zone (NAFZ) to the north, East Anatolian Fault Zone (EAFZ) to the east, Dead sea FZ and Cyprus FZ to the south. The tectonic structure of the Cappadocia region is composed of NW trending Salt Lake Fault Zone extending approximately 220 km in length, Salanda fault zone extending 140 km, and NE trending Central Anatolian Fault zone more than 700 km in length. There are 82 geothermal regions having 171 sources with low and high temperatures due to the young volcanism and tectonic activities in this region. These geothermal regions caused by fault and fracture zones extending to the mantle parallel to the tectonic zones of the region and are situated on the areas having low Curie, high heat flow values. The Curie point depth, heat flow and geothermal gradient values determined from geophysical data of the region are correlated with tectonics and geothermal potential of the region. While the minimum crustal thickness is 38 km, the maximum crustal thickness is 41 km in Mt. Hasan and Mt. Erciyes. The Curie point depth value is computed as 13.7 km determined from magnetic anomaly data of the region. The geothermal gradient and heat flow values are estimated to be 42.3 °Ckm-1, 88.8 mWm-2, respectively. Geothermal systems and reservoir temperature of geothermal sources should be understood clearly to provide sustainability of the project with respect to the economical conditions. Various geothermometers methods have been used to determine the reservoir temperature in order to estimate the field of usage of the thermal water before the drilling stage because of the high price of the borehole. Silica geothermometers method applied to the SiO2 content of the sources gives the best information about the reservoir temperature. The maximum temperatures and depth to reservoir of the geothermal sources located in the Kayseri region are estimated as 131.8 °C, 1.14 km, respectively, in Kayseri region. It is concluded from these values that the Cappadocia region has very high geothermal potential caused by tectonic activities after the Late Triassic and partial melting of the lower crust.
- Kitap BölümüYalnız künye2012Geophysical approach for the detection and evaluation of geothermal energy potential stimulated from geology and tectonics in Cappadocia region (central Turkey)
Maden, Nafiz
Geothermal energy, which is a renewable energy source, can be used to heat buildings or generate electricity and does not contribute to air pollution when used properly, and it is heat continuously produced inside the earth that generates geological phenomena on a planetary scale. Central Anatolia is a triangular region which is limited by North Anatolian Fault Zone (NAFZ) to the north, East Anatolian Fault Zone (EAFZ) to the east, Dead sea FZ and Cyprus FZ to the south. The tectonic structure of the Cappadocia region is composed of NW trending Salt Lake Fault Zone extending approximately 220 km in length, Salanda fault zone extending 140 km, and NE trending Central Anatolian Fault zone more than 700 km in length. There are 82 geothermal regions having 171 sources with low and high temperatures due to the young volcanism and tectonic activities in this region. These geothermal regions caused by fault and fracture zones extending to the mantle parallel to the tectonic zones of the region and are situated on the areas having low Curie, high heat flow values. The Curie point depth, heat flow and geothermal gradient values determined from geophysical data of the region are correlated with tectonics and geothermal potential of the region. While the minimum crustal thickness is 38 km, the maximum crustal thickness is 41 km in Mt. Hasan and Mt. Erciyes. The Curie point depth value is computed as 13.7 km determined from magnetic anomaly data of the region. The geothermal gradient and heat flow values are estimated to be 42.3 °Ckm-1 , 88.8 mWm-2 , respectively. Geothermal systems and reservoir temperature of geothermal sources should be understood clearly to provide sustainability of the project with respect to the economical conditions. Various geothermometers methods have been used to determine the reservoir temperature in order to estimate the field of usage of the thermal water before the drilling stage because of the high price of the borehole. Silica geothermometers method applied to the SiO2 content of the sources gives the best information about the reservoir temperature. The maximum temperatures and depth to reservoir of the geothermal sources located in the Kayseri region are estimated as 131.8 °C, 1.14 km, respectively, in Kayseri region. It is concluded from these values that the Cappadocia region has very high geothermal potential caused by tectonic activities after the Late Triassic and partial melting of the lower crust.
- MakaleYalnız künye2009Determination of tectonic and crustal structure of the eastern pontide orogenic belt (NE Turkey) using gravity and magnetic data
Maden, Nafiz; Gelisli, Kenan; Eyuboglu, Yener; Bektas, Osman
The Eastern Pontide Orogenic Belt is one of the most complex geodynamic settings within the Alpine belt. Subduction polarity, which is responsible for the formation of the Eastern Pontide Magmatic Arc, is still under debate because of limited geological, geophysical and geochemical data. This orogenic belt is mainly divided into three subzones depending on lithological characteristics and facies changes as in Northern, Southern and Axial Zones from North to South. These zones are separated from each other by near-vertical faults that display the block-faulting tectonic style of this belt. In this study, the tectonic and crustal structure of the Eastern Pontides, which as yet have not been prospected by using geophysical data, has been investigated with potential field data. The horizontal gradient map obtained from gravity data shows a number of steep and gentle lineaments. It seems that these lineaments E-W, NE and NW-trending correspond to major structural zones of continental crust. Additionally, The Moho depth and Curie point depth variation maps of the Eastern Pontide Orogenic Belt have been computed with the power spectral method of the radial wavenumber carried out by using the fast Fourier transform method. As a result of this method, we estimated that the depths of the Moho and Curie point varied between 29.0 ± 1.2-47.2 ± 1.9 km and 14.3 ± 0.7-27.9 ± 1.4 km, respectively. Our findings indicate that the Moho depth generally increases from north to south in the region. However, the Curie point depth level within the crust has an undulating surface, not a horizontal one.
- MakaleAçık Erişim2009Crustal thermal properties of the central Pontides (Northern Turkey) deduced from spectral analysis of magnetic data; [Orta pontidlerin (Kuzey Türkiye) kabuksal isıl özelliklerinin manyetik verilerin spektral analizi ile belirlenmesi]
Maden, Nafiz
The Pontides can be divided tectonically into three main sectors: Eastern, Central, and Western Pontides. Each of these represents an amalgamated tectonic mosaic consisting of remnants of oceanic, continental, and island arc segments. The Eastern and the Western Pontides meet in the Central Pontides, where they are structurally mixed and form a tectonic knot. The Central Pontides of northern Turkey is one of the best exposed segments of the southern margin of Eurasia adjacent to the Tethys Ocean. The study area also extends to parts of the Sakarya and Ki{dotless}rşehir continents. Magnetic spectral analysis, which has been used to estimate the Curie point depths and heat flow values, is employed to identify the thermal regime of the Central Pontides. The magnetic data of the region are separated into five subregions and the power spectra of each region is achieved by using 2D Fourier transform method to attain the average curie depth. The curie depth values changes across the studied region from 14.8 km in the south to 21.8 km in the north. The obtained results imply a high thermal gradient (39.2 °Ckm-1) and corresponding heat flow values (94.1 mWm-2) in the south of the research area. The northern part of the study area displays a low thermal gradient (26.6 °Ckm-1) and low heat flow value (63.9 mWm-2), corresponding to the Central Pontides consisting of accreted oceanic crustal material. The determined values show the heat flow decrease within the accretionary prism toward the island arc-like Pontides.