Yazarlar
- Ozyurt, E.(2)
- Wang, Y.C.(2)
Yayınlar
- MakaleAçık Erişim2019Scopus SJRQ1A numerical investigation of static resistance of welded planar steel tubular joints under in-plane and out-of-plane bending at elevated temperatures
Ozyurt, E.; Wang, Y.C.
This study presents the results of a numerical investigation on static resistance of welded planar steel tubular joints under in-plane and out-of-plane bending moments at elevated temperatures. The numerical simulations were carried out using the commercial finite Element software ABAQUS v6.14-1 and the simulation model was validated by comparing against test results for CHS joints under brace in-plane bending at elevated temperatures. Extensive numerical parametric simulations were performed for CHS/SHS/EHS joints under in-plane and out-of-plane bending at elevated temperatures, to establish a database of results covering a wide range of geometrical parameters, including brace to chord diameter ratio, the angle between brace to chord members, and chord diameter to twice chord thickness ratio. The ratios of joint elevated temperature resistance to ambient temperature resistance were compared to the steel yield strength reduction factor, the steel Young's modulus reduction factor, and the average of the above these reduction factors at different elevated temperatures. Based on the comparisons, it has been found that using the reduction factor for the yield strength of steel to modify the ambient temperature equations will overestimate the resistance of joints at elevated temperatures. As a simplified and safe recommendation, the ambient temperature joint resistance equations can be modified by the average reduction factors for the Young's modulus and yield strength at elevated temperatures. This modification factor can be increased to the yield strength reduction factor when the brace and chord widths/diameters are the same.
AtıfScopus23WoS19OpenAlex24
İncele - MakaleYayıncıda açık erişim2016Scopus SJRQ1Effects of non-uniform temperature distribution on critical member temperature of steel tubular truss
Ozyurt, E.; Wang, Y.C.
This paper examines the effects of thermal restraint, caused by non-uniform temperature distribution in different members, on the failure temperatures of critical members of steel tubular trusses. Non-uniform temperature distribution develops in trusses exposed to localised fire attack. The truss member nearest to the fire source experiences the highest temperature, with reduced temperatures in the nearby members. The number of the nearby truss members being heated and their temperatures will affect the failure temperature of the critical truss member which has the highest temperature. The aim of this paper is to develop a simplified method to account for the effects of different numbers of members being simultaneously heated to different temperatures on the development of compression force and failure temperature of the critical member. Finite Element (FE) simulations were carried out for Circular Hollow Section (CHS) trusses using the commercial Finite Element software ABAQUS v6.10-1 which has previously been validated by the authors. The simulation trusses were subjected to constant mechanical loads and then increasing temperatures until failure. The elevated temperature stress-strain curves were based on EN-1993-1-2 [1]. Initial geometrical imperfections were included, based on the lowest buckling mode from eigenvalue analysis.The numerical study examined the effects of truss type, critical member slenderness, applied load ratio and axial restraint stiffness ratio on the failure temperatures of the critical truss members. The numerical simulation results were used to check the accuracy of a proposed simplified calculation method, combining linear elastic static truss analysis at ambient temperature and analytical equations to calculated the failure temperatures of thermally restrained truss members based on the regression equations of Wang et al. [2]. The calculation method was shown to be sufficiently accurate for fire resistant design purpose.
AtıfScopus27WoS24OpenAlex26İncele