Sürdürülebilir Kalkınma Amaçları
Yayınlar
- MakaleYalnız künye2026Effects of dual and single spark plug configurations on energy, exergy, and exhaust emissions in a spark ignition engine
Altın, İsmail; Bayraktar, Hakan; Sezer, İsmet
Effects of dual spark plug (DSP) operation in a spark ignition (SI) engine on energy, exergy, and exhaust emissions are numerically investigated in this study. A quasi–dimensional SI engine cycle model is used for the analyses. The practical correlations with no assume the fluid dynamics are occupied for the simulation of intake and exhaust periods and the turbulent flame propagation analogy is assigned for the modeling of combustion. The second law of thermodynamics is added to the cycle model to execute the exergy analysis. The thermodynamic parameters such as in–cylinder pressure and temperature, ignition delay, and burn duration with the engine performance parameters are evaluated in the energy analysis. The exergies transferred via heat, work, and exhaust gases, besides destroyed exergy, fuel chemical exergy, thermomechanical exergy and total exergy are compiled for the exergy analysis. The carbon monoxide (CO), nitrogen oxide (NO), and carbon dioxide (CO2) emissions are defined for emission performance analysis. The results show that DSP operation affects moderately energy, exergy, and exhaust emissions. The best results were obtained at dimensionless spark plug location (ratio of spark plug location radius to cylinder radius–Xsp) of 0.2 for DSP compared to centrally located single spark plug (SSP).
- MakaleYalnız künye2019Theoretical investigation on combustion characteristics of ethanol-fueled dual-plug SI engine
Altın, İsmail; Bilgin, Atilla; Sezer, İsmet
In this study, effects of equivalence ratio, spark timing and spark plug number and locations on combustion characteristics were theoretically investigated using an ethanol-fueled dual-plug SI engine. Two-zone quasi-dimensional model was used throughout analyses. Three spark plug configurations (diagonally, centrally and side located), three equivalence ratios (0.8, 0.9, and 1.0), and three spark timings (−30, −25, and −20 CA @ BTDC) were considered to analyze variation of total burn duration, mass fraction burned, cylinder pressure, and temperatures (exhaust and maximum burned gas). Variation of mass fraction burned and cylinder pressure were also investigated at lean mixture ratio and 2800 rpm (MBT engine speed). Lastly, the effect of engine speed on total burn duration, maximum cylinder pressure and aforementioned temperatures were investigated in the range of 1000–6000 rpm. The findings show that dual-plug configuration yields approximate combustion characteristics by comparison with centrally located single plug configuration in ethanol-fueled SI engine.