Sürdürülebilir Kalkınma Amaçları
Yayınlar
- MakaleYalnız künye2017Finite Modeling Updating Effects on the Dynamic Response of Building Models
Günaydin, M.; Adanur, S.; Altunisik, A. C.; Sevim, B.; Bayraktar, A.
An improved finite element model was used to obtain more accurate modeling of engineering structures. The main goal of this paper was to determine how this improved modeling procedure affects the dynamic response of buildings based on experimental modal parameters such as natural frequencies, mode shapes and damping ratios. For experimental assessment, three small, one-story, two-bay, reinforced concrete buildings with raft foundation were constructed under laboratory conditions. The initial three-dimensional finite element models, built with the ANSYS software, were used to analytically identify modal parameters, including natural frequencies and mode shapes. Following the analytical study, the ambient vibration tests were performed to obtain modal parameters, experimentally. The enhanced frequency domain decomposition method and the stochastic subspace identification method were used to identify the modal parameter. The analytical and experimental modal parameters were compared and then initial finite element models were updated to minimize the differences by changing of some uncertain parameters such as materials properties. With model updating, the maximum difference between the measured and initially obtained frequency was reduced from 28.47 to 4.88%. To show the model updating effect on dynamic response of building models, dynamic analysis with the experimental computed damping ratios and 5% damping ratio were carried out using 1992 Erzincan earthquake ground motion record. For the experimental damping ratios, the maximum differences in the displacements and stresses between the initial and updated models were obtained as 23 and 32%, respectively. These differences were calculated as 43 and 15 % for the 5 % damping ratio. Comparisons of dynamic analyses results for the initial and updated model show that the finite element model updating affects the dynamic response of the buildings considerably.
- MakaleYalnız künye2017System identification of arch dam model strengthened with CFRP composite materials
Altunisik, A.C.; Gunaydin, M.; Sevim, B.; Adanur, S.
This paper presents the structural identification of an arch dam model for the damaged, repaired and strengthened conditions under different water levels. For this aim, an arch dam-reservoir-foundation model has been constructed. Ambient vibration tests have been performed on the damaged, repaired and strengthened dam models for the empty reservoir (0 cm), 10 cm, 20 cm, 30 cm, 40 cm, 50 cm and full reservoir (60 cm) water levels to illustrate the effects of water levels on the dynamics characteristics. Enhanced Frequency Domain Decomposition Method in the frequency domain has been used to extract the dynamic characteristics. The dynamic characteristics obtained from the damaged, repaired and strengthened dam models show that the natural frequencies and damping ratios are considerably affected from the varying water level. The maximum differences between the frequencies for the empty and full reservoir are obtained as 16%, 33%, and 25% for damaged, repaired and strengthened model respectively. Mode shapes obtained from the all models are not affected by the increasing water level. Also, after the repairing and strengthening implementations, the natural frequencies of the arch dam model increase significantly. After strengthening, between 46-92% and 43-62% recovery in the frequencies are calculated for empty and full reservoir respectively. Apparently, after strengthening implementation, the mode shapes obtained are more acceptable and distinctive compared to those for the damaged model.
- MakaleYalnız künye2017An Investigation of the Seismic Behaviour of an Ancient Masonry Bastion Using Non-Destructive and Numerical Methods
Altunisik, A.C.; Adanur, S.; Genc, A.F.; Gunaydin, M.; Okur, F.Y.
Determining the structural behavior of masonry structures is a challenge due to their lack of homogeneity. The seismic behavior of masonry structures is especially complex. The aim of this study was to examine the structural behavior of Zağanos Bastion using both experimental and numerical methods. The Operational Modal Analysis technique, including the Enhanced Frequency Domain Decomposition Method, and the Stochastic Subspace Identification Method were used to illustrate experimentally the dynamic characteristic of the bastion. A finite element model was developed using ANSYS software in order that the dynamic characteristics of the bastion, including natural frequencies and mode shapes, could be calculated numerically. Seismic analysis was carried out using the 1999 Kocaeli earthquake ground motion record to determine the linear and nonlinear seismic behavior of the bastion. The Turkish Earthquake Code and its general technical specifications were used to evaluate the seismic results. The results show that the maximum and minimum principal stresses exerted on the masonry components exceeded the code requirements at some points, but in general the requirements for the stresses were satisfied.
- MakaleAçık Erişim2015Static and dynamic responses of Halgavor footbridge using steel and FRP materials
Gunaydin, M.; Adanur, S.; Altunisik, A.C.; Sevim, B.
In recent years, the use of fiber reinforced polymer composites has increased because of their unique features. They have been used widely in the aircraft and space industries, medical and sporting goods and automotive industries. Thanks to their beneficial and various advantages over traditional materials such as high strength, high rigidity, low weight, corrosion resistance, low maintenance cost, aesthetic appearance and easy demountable or moveable construction. In this paper, it is aimed to determine and compare the geometrically nonlinear static and dynamic analysis results of footbridges using steel and glass fiber reinforced polymer composite (GFRP) materials. For this purpose, Halgavor suspension footbridge is selected as numerical examples. The analyses are performed using three identical footbridges, first constructed from steel, second built only with GFRP material and third made of steel-GFRP material, under static and dynamic loadings using finite element method. In the finite element modeling and analyses, SAP2000 program is used. Geometric nonlinearities are taken into consideration in the analysis using P-Delta criterion. The numerical results have indicated that the responses of the three bridges are different and that the response values obtained for the GFRP composite bridge are quite less compared to the steel bridge. It is understood that GFRP material is more useful than the steel for the footbridges.
- MakaleYalnız künye2012Determination of water level effects on the dynamic characteristics of a prototype arch dam model using ambient vibration testing
Sevim, B.; Bayraktar, A.; Altunişik, A.C.; Adanur, S.; Akköse, M.
This study investigated the water level effects on the dynamic characteristics of a prototype arch dam model using ambient vibration testing were investigated. Achievement of this purpose involved construction of a prototype arch dam-reservoir-foundation model under laboratory. The dam body was constructed with 60 cm height. Ambient vibration tests on the arch dam estimated its natural frequencies, mode shapes and damping ratios for different water levels. In the ambient vibration tests, ambient excitations are provided from small impact effects and the responses of the arch dam are measured. It can be stated from the study that natural frequencies are not overly changed among 0-30 cm water levels; however they are increased for higher water levels. The difference between the first natural frequencies of the arch dam obtained from empty reservoir (H = 0 cm) and full reservoir (H = 60 cm) is about 20-25%.
- MakaleYalnız künye2011Dynamic Characteristics of a Prototype Arch Dam
Sevim, B.; Bayraktar, A.; Altunışık, A.C.; Adanur, S.; Akköse, M.
This study determines the dynamic characteristics of a prototype arch dam-reservoir-foundation system using Operational Modal Analysis method. Achievement of this purpose involved construction of a prototype arch dam-reservoir-foundation system under laboratory conditions. Ambient vibration tests on the arch dam model identified its natural frequencies, mode shapes, and damping ratios. Natural excitations such as small impact loads vibrated to arch dam. Sensitivity accelerometers which were placed on the dam's crest collected signals in measurements. Measurements were recorded for empty and full reservoirs. Operational Modal Analysis software processed signals which were collected from the ambient vibration tests. Enhanced Frequency Domain Decomposition technique estimated dynamic characteristics of the dam. Results showed that there was an approximate 20-25% difference between natural frequencies related to empty and full reservoirs.