Bu dergideki yayınlar

3 →
  • MakaleAçık Erişim2018Scopus SJRQ4
    The investigation of the lattice strains and crystallite sizes of Y358 and Y123 high-temperature superconductors

    Duzgun, Ibrahim

    In this study, the Y358 phase, the newest high-temperature superconductor member of the yttrium barium copper oxide family, was produced using the solid-state reaction technique. The Y358 superconductor exhibited the Meissner effect at low temperature (77 K). The X-ray diffraction spectra indicated that the crystal structure was almost identical to that of Y123, but with some impurity peaks. An X-ray peak broadening analysis was applied to determine the lattice strain, and the medial crystallite size was calculated perpendicular to the surface of the superconductor specimens. As a result of the analyses, it was determined that the crystallite size of the Y358 superconductor was about 1.125 times larger than that of the Y123 superconductor.

    AtıfScopus12WoS9OpenAlex12
    ScopusWeb of Scienceİncele
  • MakaleAçık Erişim2018Scopus SJRQ4
    Single production of the excited muons at the SPPC-based ultimate μp collider

    Cąliskan, Abdullatif

    Single production potential of the excited muons at the SPPC-based ultimate muon-proton collider with center-of-mass energy of 116.6 TeV was analyzed. We calculated the production cross-sections and the decay widths of the excited muons with the process of μp → μX → γμX. We obtained the normalized transverse momentum and pseudorapidity distributions of the final-state particles to attain the kinematical cuts for the discovery of the excited muons. With these cuts, we determined the mass limits. It was shown that the discovery limits on the mass of the excited muons are 19.6 and 10.1 TeV for λ = mμ and λ=50 TeV, respectively.

    AtıfScopus3WoS3OpenAlex4TR Dizin2
    ScopusWeb of ScienceTR Dizinİncele
  • MakaleAçık Erişim2017Scopus SJRQ4
    The effect of sintering in different atmospheres on superconductivity parameters of YBCO

    Başoǧlu, Mehmet

    YBa2Cu3O7 (Y123) is a superconductor material discovered in 1987 and its transition temperature is above the liquid nitrogen temperature. It is known that superconductor samples produced by the solid-state reaction route are very often sintered in air atmosphere. However, in the presented work, Y123 was prepared by the same technique using a sintering ambient composed of a mixture of oxygen and argon gases for the first time. Critical current densities of the samples were calculated using results of magnetization measurements. It was obtained from magnetization analysis that all the samples exhibited superconductor character. It was also observed that the sample sintered in the 50% oxygen and 50% argon atmosphere showed the highest critical current density.

    AtıfOpenAlex1
    ScopusWeb of ScienceTR Dizinİncele
Tam Kayıt
AlanDeğerDil
creativeworkseries.issn1300-0101
dc.date.accessioned2026-10-22T10:18:56.515386665Z
dc.date.available2026-10-22T10:18:56.515386665Z
dc.identifier.urihttps://rdlopen.rawdatalibrary.net/r/gumushane/11361
dc.publisherTUBITAK
dc.rightsinfo:eu-repo/semantics/openAccess
dc.titleTurkish Journal of Physics